HWQS 4-канальный диммер 0-10В для установки на DIN-рейку (LQSE-4T10-D)

Power Module

The Power Module family is a group of modular products for the control of lighting loads.

 Features

• Includes QS link for seamless connection to a HomeWorksR QS system.

• Power Module units can be used in a HomeWorksR QS system to control and manage light in an entire home or building.

Power

• 230 V  50/60 Hz

• Lightning strike protection meets ANSI/IEEE standard 62.31-1980. Can withstand voltage surges of up to  6 000 V and current surges of up to 3 000 A.

• Current draw: 50 mA max

• Standby power : 1 W

• BTUs/hour when fully loaded: 4

Output Zone Ratings

• Each zone is rated at 10 AX for switching. Rated for resistive, capacitive, or inductive lighting loads as defined by IEC/EN 60669-2-1. 

• Switched outputs utilize latching relays to maintain relay state if control power is lost.

• 0-10 V rated for 50 mA maximum output, source or sink per zone.

Standards

• IEC/EN 60669-2-1, EN50428

• Lutron Quality Systems registered to ISO 9001:2008

• CE

• C-Tick S

Environment

• Ambient Temperature Operating Range (inside  mounting panel): 0 ?C to 40 ?C

• Calibration point maximum: 65 ?C

• Relative humidity: less than 90% non-condensing

• For indoor use only

Terminals

• Mains wiring: 0,5 mm2 to 6,0 mm2

• 0-10 V Wiring: 0,5 mm2 to 2,5 mm2

• CCI Wiring: 0,5 mm2 to 6,0 mm2

• Zone wiring: 0,5 mm2 to 6,0 mm2

Mounting

• Use an IP20 (minimum) rated consumer panel or breaker panel with integrated DIN rail

• Width = 9 modules (161,7 mm)

Programming and Compatibility Requirements

• LQSE-4T10-D and LQSE-4S10-D can only be used with the HomeWorksR QS system.

• Setup and programming of the DALI® Power Module is done through the HomeWorksR QS programming software.

• HomeWorks® QS software version 3,0 or higher required.

HomeWorksR QS Wallstations

• HomeWorksR QS wallstations can be configured to control Power Modules with the HomeWorksR QS programming utility.

• LED indicator displays the status of programmed lights.

QS Link Limits

• A QS link in a HomeWorksR QS system can have up to 512 zones (outputs) and 100 devices.

• Each Power Module counts as one device toward the 100 device limit. Manual Mode Operation

• Zone buttons:  —  selects zone to control

• Raise/Lower buttons:  —  turns loads on and off —  dim loads up and down (LQSE-4T10-D only)

NOTE: Program, Input, and Option buttons are not used in LQSE models.

Contact Closure Input (CCI)

• The CCI behaves as a Manual Override Closure Input.

• If the CCI is open, the Power Module unit will enter Manual Override Mode, which will turn on all loads and disable control from other devices.

• When the CCI is closed or jumpered (factory default), Power Module unit zones will return to the settings or levels they were at prior to entering Manual Override Mode.