HomeWorksR QS 1-Link Processor
The HomeWorksR QS processor provides control and communication to HomeWorksR QS system components. The Ethernet link allows communication to the HomeWorksR QS software, integration with third-party systems and communication between multiple processors. HomeWorksR QS processors may be connected using either standard networking or using ad-hoc networking. All processors on a project must be connected to a single network. The HomeWorksR QS software and all integration equipment must be connected to the same network as the processors. The processor is powered from the QSPS-DH-1-75 power supply. Refer to the HomeWorksR QS software to determine link power requirements. The HomeWorksR QS processor can be installed in an HQ-LV21, L-LV21, L-LV14, PNL-8 enclosure or DIN panels with control compartments (PDx-36 or PDx-64).
Each HomeWorksR QS 1-Link processor has one link that can be configured as one of four types:
• HomeWorksR QS Power Panels 16 interfaces / 256 zones
• HomeWorksR QS Wired Device Link 99 devices / 512 zones
• HomeWorksR QS RF Link 99 devices / 100 zones
• HomeWorksR H48 Wired Dimmers 4 interfaces / 192 zones
Typical Power Consumption: 5 W; 8 Power Draw Units (PDUs) Test conditions: Ethernet link connected, and device link in use
Link Capacities: HomeWorksR QS Power Panel Link 16 interfaces/256 zones HomeWorksR QS Wired Device Link 99 devices/512 zones HomeWorksR QS RF Link 99 devices/100 zones HomeWorksR H48 Wired Dimmers 4
Communications: Ethernet, RS485 (QS, RF, Power Panel)interfaces/192 zones
Connections: One 5-pin removable terminal block* for Link 1. One RJ45 standard Ethernet connection. *Each terminal will accept up to two 18 AWG (0.75 mm2 ) wires.